Y axis stall and Z axis stall at the same time.

[bil381]

I just changed the Y motor in my machine. I also did a thorough cleaning when I got everything put back together I immediately get a z axis stall. When I run tests it is also telling me that there is a Y axis stall as well. I am in a bit of a pickle trying to get Christmas presents done. If you all have any help that would be awesome.

[DocWheeler]

My first thought was thast it might be too cold, is the shop warm?

[bil381]

Yep I got a Heated Garage.


My first thought was thast it might be too cold, is the shop warm?

[DocWheeler]

My next thoughts were either bearings or power supply.
After that, it would be a bunch of question marks, especially if the machine worked recently.

[bergerud]

I think you should go back and look at everywhere you have been. Check that all wire connections are good. How is the x test?

[fwharris]

Make sure you have the FSC cable plugged in correctly. It can be plugged in bassackwords so the contacts are not being made.

[bil381]

X works just fine just not the Y and Z

[bil381]

Checked that and it is good. I don't know if I shorted something out or what. I used graphite to lubricate the lift and lower mechanism. I don't know if some graphite got in there and shorted something out.