DocWheeler
12-16-2013, 12:07 PM
I'm not sure if Ron still sells these, but it does a really nice job.
I made a gift tag that will be part of a box I'm making.
This 1/8" bit use to have a 1/16" cutting bit on the other end,
dropped it while trying to get it out of the old QC adapter.
I have attached the mpc of the label if anyone is interested.
Some filing is needed on the cack to add realism and allow
room for a string to be put through the hole.
6644466445
I broke the first one and made another one, after gluing I finished both
so that I had a choice after filling with paint (copper and silver).
Note: The 1/4" material needs to be turned about 15 degrees when carving
so that the grain is in line with the text. Could not figure out how to make
a pattern that included the cut-out.
I made a gift tag that will be part of a box I'm making.
This 1/8" bit use to have a 1/16" cutting bit on the other end,
dropped it while trying to get it out of the old QC adapter.
I have attached the mpc of the label if anyone is interested.
Some filing is needed on the cack to add realism and allow
room for a string to be put through the hole.
6644466445
I broke the first one and made another one, after gluing I finished both
so that I had a choice after filling with paint (copper and silver).
Note: The 1/4" material needs to be turned about 15 degrees when carving
so that the grain is in line with the text. Could not figure out how to make
a pattern that included the cut-out.