View Full Version : Model and serial number location
Azbear
02-17-2007, 09:01 AM
I know I've seen this question many times previously, but now have my machine and can't locate the numbers. Help? :?:
Azbear
In front of the machine just to the left where the power cord comes out
of the machine there is a name plate Computer Controlled Carving Machine and has the Model
and serial number is on the bar code.
Bill.
BobHill
02-17-2007, 09:34 AM
Azbear,
That's only on the Sears CompuCarve machines. On the Beta machines you have to put your Flash card in and use the LCD pad 0 then 4 to get the Serial number.
Bob
Bob,
The Sears machines work the same insert the flash card turn on machine
go 0 then 4 or use options use the arrow key up or down for serial number.
I just thought it may be more convenient to look at the front of the machine.
Bill.
BobHill
02-17-2007, 09:59 AM
That's not on the Beta Machines, Bill, which is what I really wanted to indicate for those of us who never noticed <g>. Although I didn't know the LCD method was also on the Sears Machines ... it makes sense that it would be.
Bob
The Bard
02-17-2007, 11:29 AM
yep
That's not on the Beta Machines
I'm confused...are they still shipping beta units, or are the machines that are shipping now - through Sears - actual production units?
My Serial # - which isn't called serial # or identified properly - is located on the front of the machine as noted above.
Your pal,
Meat.
Jeff_Birt
02-17-2007, 07:44 PM
There were 200 beta units sold all in 2006, none of them through Sears.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.