Comments on router bits, non-CW

[DocWheeler]

While waiting on some glue to dry, I wanted to share my thoughts on a couple of router bits.

The first set I used was to put edging on plywood, both 1/2" and 3/4" - worked great.
They can be seen here (http://www.eagleamerica.com/product/v190-2012/ea_-_glue_joints) at Eagle.
6615366152

I bought another bit to make to make edge joints that would not slip; they fit very tight.
This bit can be found here (http://www.eagleamerica.com/product/v192-1602/ea_-_glue_joints).
6615466155

As can be seen in the last picture, I had a chipout on the top piece because of the curly grain.
Also note that the joints on the end-grain edges are made differently.

The bits are a bit touchy to get set up just right, but that is to be expected.
I would recommend these bits even though they are expensive.

[DickB]

I got the second type bit from Rockler a while back (a bit less expensive there). I agree, tricky to set up, but makes a strong joint.

[Bigtyme]

I have the second type as well and learned early to always leave your stock wider the necessary if using on edge grain. I also recently found a very good gauge that eases set up. There is a you tube demo at http://www.youtube.com/watch?v=XwpRUASpZ30 . I have built several projects using this bit and gauge and like it a lot. I don't take it all in one pass, but use several passes. I set the bit up as though it would be one pass and then clamp blocks to the back of the fence and move the fence forward to take several small passes. Once the fence rests back on the blocks it is back at final set up. Works well and less chance for stock damage....

[DocWheeler]

Dick, I bought mine at Rockler also, I wasn't sure of that when I posted.
Eagle has a better selection of sizes.

John, good idea about multiple passes although I did not have any problems with the 1/2" maple I was using.
I bought a setup block, but it was for 5/8 and 3/4 material.

What I like about that bit is that you only have to clamp in one direction, and there is no mis-alignment.

The first bit-set I posted can create invisable joints with some practice.
And, you can use wider edging material to streach your plywood in order to get more out of a sheet of plywood.

You definately need a router table to make the best use of these bits.