saylesj
12-03-2013, 08:01 PM
Hi,
I tried running a project today, everything appeared to be working until it said “carving pattern” and the cut motor never started, the head was functioning like it was carving but the motor never started. I have tested the cover switches RPM sensor and checked all wire connections, they are all secure. While doing the cut motor test in the menu it stated that the motor was running and it was not… does this mean I’m in need of a new X-Termination Electronics Board or something else? When spinning the flexshaft by hand it appears to engage the motor
Thanks.
John Sayles
I tried running a project today, everything appeared to be working until it said “carving pattern” and the cut motor never started, the head was functioning like it was carving but the motor never started. I have tested the cover switches RPM sensor and checked all wire connections, they are all secure. While doing the cut motor test in the menu it stated that the motor was running and it was not… does this mean I’m in need of a new X-Termination Electronics Board or something else? When spinning the flexshaft by hand it appears to engage the motor
Thanks.
John Sayles