smurfjeep
11-29-2013, 08:30 PM
Hello all,
I am working on a sign for a friend who has one of the special edition Camaro's, the Hot Wheel Model. I wanted to make a sign that he could display when he has his hood open at cruise nights.
I am very new at this program and was wondering if anyone can assist me. I am using the spline tool to trace a drawing, and manipulating the carve region depths to get the desired effects. My question is how I can make the "O" so that the inner donut hole is lower than the O. I am going to have the same problem when trying to design the little "e" in Wheels.
Thanks for any advice. (did I say I have o Idea what I am doing?)
I am working on a sign for a friend who has one of the special edition Camaro's, the Hot Wheel Model. I wanted to make a sign that he could display when he has his hood open at cruise nights.
I am very new at this program and was wondering if anyone can assist me. I am using the spline tool to trace a drawing, and manipulating the carve region depths to get the desired effects. My question is how I can make the "O" so that the inner donut hole is lower than the O. I am going to have the same problem when trying to design the little "e" in Wheels.
Thanks for any advice. (did I say I have o Idea what I am doing?)