PDA

View Full Version : Need to buy additional software/modules?



NLAlston
11-28-2013, 01:46 AM
I bought the Centerline software/module, primarily for a particular text layout that I knew I'd be interested in. I aim for being able to wrap text around arched surfaces, and thought that Centerline was what would be needed. But I just finished reading a post where the OP expressed a similar concern, and was informed of the fact that he'd need to purchase a $50 module, in order to achieve what he wished to do. Of all the researching that I did, since becoming interested in the CW, I kinda missed the boat on that one.

eelamb
11-28-2013, 07:50 AM
If the text is on the surface of the board then the extra is not needed. If the text is on a pattern, then you will need to conform vectors to make the text conform to the surface of the pattern.

NLAlston
11-28-2013, 11:58 AM
If the text is on the surface of the board then the extra is not needed. If the text is on a pattern, then you will need to conform vectors to make the text conform to the surface of the pattern.

Thank you.