PDA

View Full Version : santa ornament



aokweld101
11-24-2013, 01:22 PM
I posted this pattern awhile back finished them today, thought I would post it again with it finished.

Bigtyme
11-24-2013, 02:34 PM
Nice job on the ornaments. aok. Very good painting job on them as well...

TerryT
11-24-2013, 03:00 PM
Nice! Kinda puts you in the Christmas mood!!

peep
11-24-2013, 03:36 PM
I like, I like

Proctorw
11-24-2013, 03:47 PM
Looks great. A couple of questions, what is the thickness of the wood? I am assuming you cut more than one at a time and use a sled? I haven't tried anything thinner than 3/4". Any advice on cutting thinner wood?

aokweld101
11-25-2013, 12:46 PM
I used, 1/4" x 5 1/2" x 48" and used 1/2" and taped to the sled the same size with masking tape.

Underdog
11-25-2013, 01:51 PM
And.... of course I can't open it. Don't have Designer. :(

bergerud
11-25-2013, 02:36 PM
It opens in 1.187.

Underdog
11-25-2013, 03:46 PM
Apparently, even though I've registered this copy on my work PC, I have to register it AGAIN. How annoying...

lynnfrwd
11-25-2013, 03:51 PM
Apparently, even though I've registered this copy on my work PC, I have to register it AGAIN. How annoying...

I deactivated your work computer to free up those licenses.

Here are some reasons why it may have lost it's registration:

Why does my registered computer suddenly tell me I need to register, again?
Our system identifies registered computers by their unique Computer IDs. The computer ID on our registration server must match your computers ID. If it does not, then the software asks you to register that computer. Most of the time, the need for re-installation is obvious, such as replacement of the hard drive or because you have gotten a new computer to replace an old one. There are other instances that are not so obvious. Several things that can be done to your computer such as changing or updating your operating system or cleaning your system (running virus scan) that will result in a change to your computer ID. So even if you didn’t get a new hard drive or PC, some changes to your system may have occured to change your ID and cause loss of registration.

Underdog
11-25-2013, 09:01 PM
Darn. I just had got it reregistered.

lynnfrwd
11-25-2013, 11:28 PM
I don't think that I deactivated a good registration, did I? That was 7 hrs ago. If it is working for you now, don't update until we figure it out tomorrow.

Underdog
11-27-2013, 10:26 AM
It's still working. I was too busy yesterday to even think about it. So I don't know what you did, but it didn't seem to affect my ability to get into Designer.

By the way, aokweld, thanks for the great Santa pattern!