jdlink01
11-21-2013, 11:10 AM
Hey anybody,
I seem to have stripped the 4mm hex head on the "grab paw with screw" part of my collet. I tried to loosen it with some WD40 and it will tighten and loosen to a certain point, then stop, then the hex head rounded. Anybody have any suggestions as to how to remove the screw so I can replace it? And why is it only moving in and out so far?
Thanks for the help
Josh
I seem to have stripped the 4mm hex head on the "grab paw with screw" part of my collet. I tried to loosen it with some WD40 and it will tighten and loosen to a certain point, then stop, then the hex head rounded. Anybody have any suggestions as to how to remove the screw so I can replace it? And why is it only moving in and out so far?
Thanks for the help
Josh