PDA

View Full Version : pocket cut paths



aokweld101
11-04-2013, 10:22 PM
I'm wanting to make a cut path to save time... on the outside having the angles is throwing me off I have the inside raised and the outside lower I'm wanting to make a cut path to the low side I don't have a problem with rectangles if someone can show me how to start this at least with the first two cut paths I can do the rest I'm using a 1/8 cutting bit. thank you

fwharris
11-04-2013, 10:57 PM
First remove your cut paths and carve regions, leaving just your drawn shapes. Hi light the outer shape and assign your bit (note if you have the 3/16" bit it will be a faster carve) and set the depth you want. Next, select your outer shape again and use the "path offset" tool. In the "distance" box input 1/2 of the bit diameter. Select your new lines and repeat the copy offset and continue to do so until you have your path area completed.