cribbage board help with resizing

[scoobie_6]

hi i got the cribbage board table pattern from woodwisdom and it was setup for a 12inch wide board and i need to figure out how to resize it to work on a 8 1/2 inch board can anyone help me with this?:?:

[henry1]

you have a privet message

[lynnfrwd]

You cannot resize projects with drill holes.

[scoobie_6]

ahh ok thanks, is there any where i can find out how to setup holes for cribbage boards

[bergerud]

Actually you can resize with drill holes. It is just that the drill holes will not resize. In this case, that may be what you want. You can select all (or group) and then resize by dragging the corner handles. The pin holes will move relative to each other but not change their size. Try it and see if it is what you want to do.

[henry1]

Actually you can resize with drill holes. It is just that the drill holes will not resize. In this case, that may be what you want. You can select all (or group) and then resize by dragging the corner handles. The pin holes will move relative to each other but not change their size. Try it and see if it is what you want to do.
Bregerud I already resized it for him by copy and past on to another board work great

[lynnfrwd]

You cannot resize projects with drill holes.

Maybe, I'm thinking you can't "shrink to fit board" during machine set up with drill holes....

[TerryT]

Yes you can resize. You should have a PM I sent earlier when you asked for help with this in the private message.