View Full Version : STL Help
James RS
10-27-2013, 12:29 PM
I have a stl file I imported and I was wondering if there'd be a way to
make vector paths of the pattern. I'd like to speed up the process
using a 3/8" round nose bit, I have a few of these to make.
I tried to upload the file, it's too large
Thanks
Jim
bergerud
10-27-2013, 01:02 PM
It is hard to know what you want to do without the file or a picture. Could you post a screen capture?
James RS
10-27-2013, 02:31 PM
Here it is at a angle
65506
bergerud
10-27-2013, 02:41 PM
So you want to be able to "carve" with the 3/8 round nose. I do not think there is a way. You would have to make a large number of different paths to be routed at different depths. It would probably take longer anyway. I think your best bet is to use the 3/16 ball nose as the pattern bit.
James RS
10-27-2013, 03:37 PM
Ok I'll look into that
Powered by vBulletin® Version 4.2.5 Copyright © 2025 vBulletin Solutions Inc. All rights reserved.