myshop1044
10-15-2013, 02:08 PM
I have holes laid out that show dimension to the edge of the board and maybe the center line if it is close enough
to the center line. What is the command to check the hole distance back to the center line no matter where it lays on the board.
I want reference all the holes back to both center lines and let the outside edge float. My sled might off a fraction of an inch and
the counter sink holes in the back don't line up with drill holes on the front. It looks good on the mpc, but does not come out on the test.
Perry B.
to the center line. What is the command to check the hole distance back to the center line no matter where it lays on the board.
I want reference all the holes back to both center lines and let the outside edge float. My sled might off a fraction of an inch and
the counter sink holes in the back don't line up with drill holes on the front. It looks good on the mpc, but does not come out on the test.
Perry B.