View Full Version : Miss CurveWright Sells a CarveWright
bergerud
10-05-2013, 07:17 PM
A acquaintance of a friend of mine was visiting from the States and saw a Miss CurveWright which I had given my friend. It was just the rough figure carved in the board which he saw but that was enough. He bought a CW machine when he got back to the States.
To review an old post on her, see
http://forum.carvewright.com/showthread.php?18176-Miss-Curvewright-2-0&p=153355#post153355
(http://forum.carvewright.com/showthread.php?18176-Miss-Curvewright-2-0&p=153355#post153355)Sorry, the mpc is 2.0 only.
fwharris
10-05-2013, 07:28 PM
Worth the price of admission I would say!!! :D
SteveEJ
10-05-2013, 07:47 PM
The detail is eye grabbing!
henry1
10-05-2013, 07:56 PM
A acquaintance of a friend of mine was visiting from the States and saw a Miss CurveWright which I had given my friend. It was just the rough figure carved in the board which he saw but that was enough. He bought a CW machine when he got back to the States.
To review an old post on her, see
http://forum.carvewright.com/showthread.php?18176-Miss-Curvewright-2-0&p=153355#post153355
Can you put it in .187 so to carve
bergerud
10-05-2013, 08:07 PM
Can you put it in .187 so to carve
Sorry Henry. She is not compatible with 1.187. The floor feather screws up the boundaries and cannot be fixed in 1.187. Time to buy Designer 2.0!!
badbert
10-05-2013, 11:09 PM
Can you please share the STL? Although she is a little thin for my taste! LOL
bergerud
10-06-2013, 01:58 PM
Sorry Bert but an STL of this is 30Mb (15Mb zipped). Here are png's .
badbert
10-06-2013, 02:56 PM
That will work too! Thank you!
normrichards
03-28-2017, 12:41 PM
I know its an old thread but this is the coolest CW project I have seen.
CarverJerry
03-28-2017, 02:24 PM
Cool, and I do remember that old thread. I also agree with badbert, need a little meat on those bones. LOL
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.