Geophyrd
10-05-2013, 09:45 AM
Because I had problems with the last carve (z-axis failure), I've tried going through as many tests as I could find on the menu system. I have a couple of questions...any help would be greatly appreciated!
The following are the test results:
x 109.73 168.35
y 57.16 256
z 49.52 122.7
I have no way to know what these mean...are they in normal range?
Also, the cut motor test didn't actually turn the motor on...
Last, the bit itself is a little discolored...kind of a blue-grey sheen on the metal. Does this mean its ruined?
Again, any help would be a lot of help! Thanks in advance!
The following are the test results:
x 109.73 168.35
y 57.16 256
z 49.52 122.7
I have no way to know what these mean...are they in normal range?
Also, the cut motor test didn't actually turn the motor on...
Last, the bit itself is a little discolored...kind of a blue-grey sheen on the metal. Does this mean its ruined?
Again, any help would be a lot of help! Thanks in advance!