PDA

View Full Version : Adding 1/32 Carving Bit for the Carvewright



chief2007
09-24-2013, 08:00 AM
More of a wish list item, but would be great to add this to the Carvewright. I also know it would required software updates, but this could really open the doors for very fine detail work with the Carvewright.

Program the software and step over rate to allow the use of a 1/32 carving bit. The detail that could be added to carvings would be great with that small of a carving bit. I understand that there is also more to the programing changes - but this would be a great addition to Designer and could possibility be added to the Designer 3.0 software

Carve times would be longer, but for smaller more detailed carvings, this would really open some doors. I know that tapered 1/32 bits with 1/4 shafts are available. So if LHR would consider the software changes, I think it could be a win win for all.