View Full Version : House Sign
Firefighter938
09-13-2013, 11:10 AM
Here is a sign I made for my Grandmothers House. Does anyone have any other free plaque or signs deigns? 64619
fwharris
09-13-2013, 11:17 AM
Just in case you have not seen this http://forum.carvewright.com/showthread.php?21181-Pattern-Sharing-Depot-Attachment-List&p=182823#post182823
It will take you to the pattern sharing section. You might find some there... lots to sort through.
bergerud
09-13-2013, 11:22 AM
Very nice sign. A observation: see the vertical line after the second 4 ? This was (probably) caused by not staying under the rollers. As the edge of the board came out from under the rear roller, the board lifted up slightly.
Firefighter938
09-13-2013, 11:49 AM
Very nice sign. A observation: see the vertical line after the second 4 ? This was (probably) caused by not staying under the rollers. As the edge of the board came out from under the rear roller, the board lifted up slightly.
I assumed that's what happend. I was working with a scrap piece almost to short for the project. I have to build a jig so I can work with shorter pieces and not waist so much wood. Thanks for the info! (Still very new at this)
Digitalwoodshop
09-13-2013, 12:17 PM
This trick works when you need to add wood... I put a 4 inch dead area on the right side of designer and use place on end rather than center on board.
Nice Sign !!!!
AL
gwhiz
09-13-2013, 12:24 PM
I assumed that's what happend. I was working with a scrap piece almost to short for the project. I have to build a jig so I can work with shorter pieces and not waist so much wood. Thanks for the info! (Still very new at this)
An approach that I use quite frequently to prevent this is to simply tape a piece of scrap wood the same thickness as the project on the end of the project board. It's handy for one-off's where you don't want to go to the trouble of making a jig...
Firefighter938
09-13-2013, 07:34 PM
My mom was not happy that Grandma got a house sign and she didn't! So I made here a cedar sign to match her cedar house. 64638
ktjwilliams
09-16-2013, 09:48 AM
I like the shapes and the edge work,,, Would you share the sign design ..
cestout
09-16-2013, 07:04 PM
I use a hot glue gun to attach pieces to the ends, and for a one sided carve, the attached piece does not have to be full width - just wide enough that the little eye sees it.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.