mrtaz
09-02-2013, 08:03 PM
I had some old carvings that I hang on to so I can copy,paste or enter different text so I don't have to make the whole design all over. I down loaded the new designer with no problems so far. I had a couple of projects to do, so like always I opened one I've already did and just changed the text and then ran it. I don't know if you can see them, but in the first two pictures you can see vertical lines. look at the stained one, same thing with the lines. so I ran a test piece and made it from scratch (new version), look at the yellow board. no lines. I was wondering if some one else has experienced this same thing. Is there a problem when running projects that I've saved to run again at a later date and now running them in the 2.002? That will suck if I have to redo my projects so they are done in the new 2.002.
Hopefully will have the answer.
Thanks, Bill
I believe I just found the problem, I forgot at the same time of the upgrade I changed my "y" belt. took a closer look and I believe the truck was not tight enough on the track, causing the vibration. going to run another project tomorrow night. That's what it was.
644166441764418
Hopefully will have the answer.
Thanks, Bill
I believe I just found the problem, I forgot at the same time of the upgrade I changed my "y" belt. took a closer look and I believe the truck was not tight enough on the track, causing the vibration. going to run another project tomorrow night. That's what it was.
644166441764418