Looking to purchase

[Sliverfoot]

I am a new member to the forum but have been reading quite a few of the posts prior to registering. I am looking to buy a used machine and though I've been watching ebay and craigslist I thought that this is probably the best place to ask, you guys know whats good and whats not. I would like a new one but the funds just aren't there, I only wish.
I'm hoping someone out there can help me out or even point me to one outside of the forum.

[Canemaker]

Where are you located? There will be at least $80 just in shipping cost to consider
if funds are tight. If we know where you live, someone might know of something
close to you that could be picked up. Be sure that the person shipping it has all
original packaging that will assist in the shipment.

[Sliverfoot]

I'm in Wisconsin.

[JuicyCarp]

Silverfoot,

I am selling my machine as listed below. What is your budget?

CarveWright Version C (less than 200 hours)
Heavy Duty Traction Belts
Project Designer Software
Scanning Probe
Decorative Bit Set
1/16" Carving Bit x2
1/8" Cutting Bit
3/16" Carving Bit
Memory Card Programmer
Memory Card
Dust Devil Dust Collection Hood

[ktjwilliams]

How Much ???? And where R ya ??? I'm looking for a 2nd machine ...