rcdages
08-13-2013, 09:02 AM
Hello All,
Here is a tip that I hope all can use.
When I get ready to carve anything, I take a Dryer Sheet and I wipe down the inside of my CNC and then I wipe over the D/C unit coming out of the machine. It makes a differents.
Hope this tip might help out.
Here is a tip that I hope all can use.
When I get ready to carve anything, I take a Dryer Sheet and I wipe down the inside of my CNC and then I wipe over the D/C unit coming out of the machine. It makes a differents.
Hope this tip might help out.