edzbaker
02-11-2007, 07:28 PM
Has anyone had a problem with the cut motor speed fluctuating badly ? I have searched this toppic and was unable to find anything.
My cut motor speed started fluctuating badly, after only three hours of use. The Flex shaft checks out OK, but the fluctuations are bad enough to cause the flex shaft to jerk. I removed the flex shaft and checked the cuting head bearings, and they seem to be fine. The Voltage in my shop is a steady 110V. I have checked ALL cables and wires, nothing loose. Any suggestions ??
My cut motor speed started fluctuating badly, after only three hours of use. The Flex shaft checks out OK, but the fluctuations are bad enough to cause the flex shaft to jerk. I removed the flex shaft and checked the cuting head bearings, and they seem to be fine. The Voltage in my shop is a steady 110V. I have checked ALL cables and wires, nothing loose. Any suggestions ??