Dan-Woodman
02-10-2007, 08:57 PM
I have used the miter and bevel before, and I had a project today that was 5 1/2" wide that I needed a bevel on. I did'nt want to readjust my tablesaw so I used the cw.
It was simple and easy.
Everything is done from the keypad.
I needed the end of the board beveled at 53 deg.
Its all done with a 1/4" roundnose bit , really works great.
Got to go time for Drag Racing.
later Daniel
I'm not sure if all these features are available for sears machines.
It was simple and easy.
Everything is done from the keypad.
I needed the end of the board beveled at 53 deg.
Its all done with a 1/4" roundnose bit , really works great.
Got to go time for Drag Racing.
later Daniel
I'm not sure if all these features are available for sears machines.