PDA

View Full Version : Try the Bevel & Miter



Dan-Woodman
02-10-2007, 08:57 PM
I have used the miter and bevel before, and I had a project today that was 5 1/2" wide that I needed a bevel on. I did'nt want to readjust my tablesaw so I used the cw.
It was simple and easy.
Everything is done from the keypad.
I needed the end of the board beveled at 53 deg.
Its all done with a 1/4" roundnose bit , really works great.
Got to go time for Drag Racing.
later Daniel
I'm not sure if all these features are available for sears machines.

liquidguitars
02-11-2007, 01:15 PM
I gave the cut board to size a try yesterday just to test it and it works just fine, My cutoff saw too farway now :)