Torn X-Drive Conveyor Belt

[deron]

I need a replacement belt (X-Drive Conveyor Belt) any ideas of where I can purchase one?? Carvewright is asking $134.00 for the belt and assembly, I just need a belt. Thanks

[bergerud]

http://store.carvewright.com/search.php?mode=search&page=1

[Rob Mulgrew]

The sandpaper belts alone are only $16.50 if that is what your looking for?
http://store.carvewright.com/product.php?productid=16150&cat=0

[Digitalwoodshop]

Did you understand why the belt broke? Tapered Wood, Rolled Under Belt, Wood installed on a Angle....

Normally you just replace the belt... Did a drive gear snap?

AL

[deron]

Hi Al, I have not checked that part out yet, I hope not. Thanks for the reponse guys.

[deron]

I checked the drive gear and it is ok. I was not operating the machine at the time but I beleive the board may have been on top of the adjustable slide bar that hold the wood in place. Thanks again