View Full Version : USMC Emblem from the Probe
Here is as the MPC file of the Eagle Globe and Anchor I created with the probe. This was the first thing I did with the probe. The Original was just over an inch high. I carved it at .740 and .500 and received good detail.
BobHill
02-10-2007, 12:24 AM
That did a great job. Hmmm. I've got some stuff that should probe well too.
Bob
Thanks, It really carves nice. A closer grained wood would help also, but it did not take much to clean up.
Now I am working on developing lettering that will raster with rounded edges. My signs will look a lot better.
Semper Fi Dan
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.