PDA

View Full Version : Blast gates



unitedcases
05-21-2013, 03:07 PM
Currently I am pulling two 4in hoses on my 1hp grizzly. No complaints on power, however the plastic harbor freight blast gates tend to get dust wedged up into the small circular slots not allowing them to close. Quite a pain. I need to get new ones and would rather shell out money for good ones vice cracking more plastic ones. Does anyone have any advice on what brand or who to buy from. Thanks in advance.

Sent from my ADR6300 using Tapatalk 2

stanv77
05-21-2013, 05:04 PM
I have the plastic one also and had the same problem. So I went to cast aluminum for harbor freight and had no problems with them yet.

unitedcases
05-21-2013, 08:51 PM
Upon doing a little research I have found the self cleaning ones that are open on both ends. I shall order those.

Sent from my ADR6300 using Tapatalk 2