View Full Version : Error
rcdages
04-29-2013, 09:54 AM
Hello All,
Have any one ever gotten this error message?
Z Axis Stall
Err E06-0303
chebytrk
04-29-2013, 10:09 AM
I did a while back. I went in and cleaned out rollers (both sides) with air compressor and reset the head pressure and it worked good after that.
rcdages
04-29-2013, 10:18 AM
Hello Jerry,
When I go home tonight I'll try that.
Will keep you posted if that worked.
liquidguitars
04-29-2013, 10:28 AM
I think that the one when the carving bit is choked up to far in the chuck.. try to lower the carving bit in the chuck...
rcdages
04-29-2013, 10:40 AM
LG,
It carved fine it was on the cut out is when I got the error message.
fwharris
04-29-2013, 10:47 AM
Check to see if you have a hole in the touch plate @ the brass roller..
Digitalwoodshop
04-29-2013, 11:02 AM
Since it was carving when it happened I vote for a Dirty Encoder Disk... And since you are a 2007 member, do you have the newer 14 pin FSC Cable or the older 18 pin FSC cable. This was a common error for a failure of the old 18 pin cable.
AL
liquidguitars
04-29-2013, 11:09 AM
I agree and check the bearings..
bergerud
04-29-2013, 11:43 AM
LG,
It carved fine it was on the cut out is when I got the error message.
Could it be a very dull cutting bit? Z stall trying to plunge down to the cutting depth.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.