PDA

View Full Version : copying to the backside of the board



aokweld101
04-14-2013, 09:54 PM
Iv'e tried everything in my thinking arsenal to copy to the backside of of a carve I'm wanting to do the left and right side, I have the deer shelf the way I want it and did the front side opposite of the deer shelf for deer shelf 2 but don't know how to get the back side turned around on deer shelf 2...

DickB
04-15-2013, 08:17 AM
I think you will have to drag the rectangles to the correct locations on 2. You can use constraints to locate them in exactly the same place as 1.
If you have a large enough board, you could place side 1 to the left and use the mirror function to duplicate everything for side 2.
I got a warning about duplicate vertices when I loaded your mpc.
What is EdgeRout?

SteveNelson46
04-15-2013, 10:17 AM
This is DickB's suggestion. Also, I would make the height of the dado for the back the same as the outside distance between the top and bottom shelves and the same depth as the shelves grooves. Not absolutely necessary but, a lot easier to put together.