View Full Version : 2-sided carve
aokweld101
04-03-2013, 07:57 PM
I'm trying to do a two sided carve. I'm trying to learn a little more on pushing these buttons it doesn't look like the back feet are lined up on the reverse side, I also wanted to know if it tapers on the cut out, if it does ..great..if it don't how could I do I change that to feather the cut outs?
badbert
04-03-2013, 08:58 PM
That's cause they are not the same size front and rear!
DickB
04-04-2013, 08:22 AM
What badbert said. You should study this tutorial: http://www.carvewright.com/assets/tips/CarveWrightTips_and_Tricks_Sept09.pdf. Your pattern is not well suited for what I beleive you are trying to do. It looks like it was derived from a drawing. To do what I understand you want to do, you need a quality pattern with rounded edges.
aokweld101
04-04-2013, 01:14 PM
I wasn't doing that as a project and was trying to learn how to do it, and I did learn a little bit more on the 2-sided carve my thanks go to you guys..
badbert
04-05-2013, 01:37 AM
The easiest way to do this, Is lock the pattern in place with center both. When you get the pattern how you like it, on the front side, copy it and then set your cut path. Click the R icon to flip the board and then paste the pattern. Use flip to get it to match the cutout. Since you copied it from the front side. The one you paste onto the back will be identical in size. And locked in position by the center restraints.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.