PDA

View Full Version : Bit cleaner



Kmbzak
03-31-2013, 05:41 PM
I have been cleaning and scrubbing my bits with thinner, but I switched to an can of spray carburetor cleaner and a brass brush and it is working out well. Just thought I would pass it on...

unitedcases
03-31-2013, 06:41 PM
I stole my wifes oven cleaner. Works well. And smells like lemons!

Sent from my ADR6300 using Tapatalk 2

Digitalwoodshop
03-31-2013, 06:41 PM
Carb Cleaner some bad stuff.... Can cause Cancer... ( My Opinion) Don't use in a enclosed space and NOT in a basement shop.... Expose your family....

Sure it works GREAT... Just be careful...

AL

SteveNelson46
03-31-2013, 06:53 PM
I've been using CMT Orange 2050 Blade and Bit Cleaner (Woodcraft) to clean my bits and blades. Messy but works good.

Kmbzak
03-31-2013, 10:58 PM
Thanks I think I'll try the oven cleaner. I had about 6 bits that were all gummed up so I gave it a shot. My workshop is not attached to the house it is an 18 x 35 building and well aired. Thanks for the advice.