View Full Version : Army Aviation
JuicyCarp
03-21-2013, 01:33 PM
Good afternoon guys!
I am looking for the Army Aviation insignia, I checked the pattern depot and did not find them, and I did not find them on the forum. I thought I would reach out and see if anyone might have the .mpc. I would greatly appreciate any input!
Thanks again
Kevin
James RS
03-21-2013, 03:31 PM
Just something I did up quick, from your picture
6109861099
badbert
03-21-2013, 05:03 PM
Thought I would give it a try!
Alan Malmstrom
03-21-2013, 06:37 PM
I could do this for $18. That would be nicely rounded and wedged feathers in 3D.
RogerB
03-21-2013, 06:46 PM
Nice job badbert looks good.
TerryT
03-21-2013, 07:08 PM
There is a really nice one here....
http://www.vectorclip3d.com/?ses=&id=3&titre=§ion=product_info&manufacturers_id=&products_id=2785&zone_id=
henry1
03-21-2013, 07:11 PM
Nice job badbert looks good.your the man
RogerB
03-21-2013, 07:17 PM
Terry they have a lot of nice patterns.There is also there crib boards (still having a hard time setting up the holes have you had any luck)
TerryT
03-21-2013, 08:05 PM
I haven't tried their crib boards. I don't have the dxf importer or I would have. I'd like to know how it goes though, so let me know.
Alan Malmstrom
03-21-2013, 09:59 PM
There is a really nice one here....
http://www.vectorclip3d.com/?ses=&id=3&titre=§ion=product_info&manufacturers_id=&products_id=2785&zone_id=
That is a nice one Terry. I don't know how much it costs but that is what I could do for $18
JuicyCarp
03-22-2013, 06:52 AM
Gents,
I appreciate all the input! You guys are awesome.
Kevin
bjbethke
03-22-2013, 11:47 AM
I offer a DVD file of the DOD, PM me with an e-mail for details and samples.
billybehr
04-12-2016, 06:10 PM
Do you have this available as an STL or DWG or some type of CAD? I still have the MPC, but don't have the ability to convert it.
Thanks,
Bill
bjbethke
04-12-2016, 10:55 PM
Do you have this available as an STL or DWG or some type of CAD? I still have the MPC, but don't have the ability to convert it.
Thanks,
Bill
Attached is a STL - DWG -and DXF -will this work?
The STL file was too large - 4.9MB; Max is about 2 MB
If you "PM" me your e-mail address I can send it to you. BJB
billybehr
04-13-2016, 11:25 AM
Thank you so much. Y'all are so great here.
Bill
bjbethke
04-14-2016, 12:02 AM
Thank you so much. Y'all are so great here.
Bill
Thank you for sending me your e-mail, I will try my best to respond to you in the morning -(when I get some sleep) - hope I don't over drive e-mail with the stuff I will send you - BJB
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.