howsharbell
02-05-2007, 11:54 PM
Alright guys, third project third bleepin' issue. This time the project finished the carving part and asked to put in the 1/8" cutting bit. so I exchanged the bit and hit enter. It started with the basic scanning like before it starts a project but then it stopped and gave me a
"fatal error ( 2)!"
and asked me to reboot the machine. When I rebooted it restarted just like I had first turned it on.
Two questions (well, not really but for sake of simplicity):
1. what was this error and why did it happen?
2. how do i get my maching to start where it stopped without ruining the piece?
Please help me feel like I shouldn't take this back tomorrow!
Shari
"fatal error ( 2)!"
and asked me to reboot the machine. When I rebooted it restarted just like I had first turned it on.
Two questions (well, not really but for sake of simplicity):
1. what was this error and why did it happen?
2. how do i get my maching to start where it stopped without ruining the piece?
Please help me feel like I shouldn't take this back tomorrow!
Shari