Sharing some future kindlnig

[alexa]

Here are some of the projects I have used to learn about the software and hardware.

Al

[1turbofocus]

Why dont you put those in the share section , Great work

Tom

[Rickrljones]

Super nice job on the projects, keep up the excellant work.

[exGenius]

I am a new guy and therefore you can assume that I know very little about the CarveWright system - I am attempting to convert an *.mpg to a *.mpc that can be recognized by CarveWright as a valid pattern - I can load the *.mpg into the pattern editor but cannot go further, so I cannot upload to the flashcard where the pattern can be carved - It appears that you have accomplished this so I would appreciate an assist on this matter -

Thanks from exgenius

[exGenius]

I am having difficulty changing an imported *.mpg into a *.mpc that can be uploaded tobe carved - I would appreciate any assistance you can render -

Thanks
exGenius

[Jeff_Birt]

An .mpg file is an audio file, has nothing to do with the CW. Do you mean a PNG file? If you have loaded the file into the pattern editor you need to save it as a pattern file to your library. Then you create a new project in Designer, open the library, place you pattern, etc.

Take a look at the tutorials the CW has provided: http://www.carvewright.com/cms/tutorials, that should help get you started.

[CustomWestCoast]

Alexa,

The projects look great. Did you buy some of the patterns that you used?

[oldjoe]

Alexa looks like you are a learning quite well great looking projects,

[ChrisAlb]

If that's your "learning" work Alexa, I'd say you're well on your way!! Keep it up!

[hotpop]

Hey Guys,

Look at the dates. The original post was almost 2 months ago.

[Kenm810]

Hey Guys,

Look at the dates.
The original post was almost 15 months ago http://www.carvewright.com/forum/images/smilies/icon_razz.gif Little over a Year got lost some where!

[oldjoe]

All I can say is;

DOH!