PDA

View Full Version : VectorArt3D Patterns



Rickrljones
02-05-2007, 02:47 PM
I just carved a pattern from VA3D, tryed to increase the depth of carve, on a recessed model and Designer told the CW to carve a feathered edge instead of a dished pattern... The default depth is 1/4". Has any one else run accross problem, if so ideals on how to correct this.
Thanks

HandTurnedMaple
02-05-2007, 03:05 PM
I was able to duplicate that with the free FDL dish pattern. Try setting either your depth to .125 or your height to 200.

Rickrljones
02-06-2007, 05:22 PM
Will give a try, thanks for the advise

HandTurnedMaple
02-06-2007, 05:40 PM
I may not have answered this correctly. The answer you probably want is to turn off feather setting in Designer. It tends to default to 1/4" feather. But I only buy the normal VA patterns and tell it to recess if that's the look I want.

Rickrljones
02-06-2007, 09:38 PM
What is the free FDL Pattern

HandTurnedMaple
02-06-2007, 09:40 PM
VA3D has a free flower thing and a fleur-de-lis (or however you spell it).

pkunk
02-06-2007, 10:05 PM
here http://www.carvewright.com/forum/viewtopic.php?t=336