PDA

View Full Version : Sword stand



kcc2012
02-07-2013, 02:38 AM
My oldest son purchased a Japanese katana made from Damascus steel. I am looking for a nice pattern for a display stand for his sword.
Thank you

normrichards
02-25-2016, 06:33 PM
Oscar made a real nice one, hopefully he will see this and post the pattern.

http://forum.carvewright.com/showthread.php?27800-AR-rifle-katana-display-stand/page2&highlight=sword+stand

oscarl48
02-26-2016, 06:55 PM
Norm, the thread is from way back. Not sure if my AR/katana stand is something folks want but here it is. Unfortunately its in designer 2.0. I have no idea how to change mpc's to designer 1.

Is there a tutorial out there?

The main reason I had not share these was I did a lot of hand work and some traditional woodworking to finish the stand using several other tools. I didn't use any instructions and I didn't document anything I did so these mpc's are pretty barebones, but they could be a good starting point to develop a design. The cross piece has kanji with the words strength, honor, and courage.

Regards,
Oscar