PDA

View Full Version : not carving right



ALFRED MORENO
02-05-2007, 01:15 AM
I am a newbe, your forums have been very helpful. I recently purchased my carver and did a few pieces that turned out well. Now my carver is starting well, but after a few passes begins to raise the cutting blade until it actually is working above the piece (ghost cuttiing). Any sugestions?

menewfy
02-05-2007, 07:35 AM
yup call CW they open at 9 am central time
good luck

captainkidd
02-05-2007, 03:10 PM
I just replaced my Z-motor and encoder and now this actually happened to me on one test. Ran another test on another piece of wood and it didn't seem to do it but still a bit disconcerting just the same. Anyone else have this problem?


B.Kidd