PDA

View Full Version : Pattern Shifting on board



dspadell
02-05-2007, 12:26 AM
Here is one that I haven't seen covered here yet. While I am carving a project, starts out fine then it shifts to the left or right for a bit then back to normal then repeats. I checked my cables and they are all seated properly. Anyone have this happen to them? Have any ideas what to check?

menewfy
02-05-2007, 07:40 AM
did you move the guard in tight so it did not move?
did you lock the head down?

can you attach the design for some guys that know what to look for (not me) they can tell if it is your mach or design.

and if all fails try another design and see what is what.

good luck

dspadell
02-05-2007, 09:13 AM
I had the machine setup right. this occurred after replacing the z motor pack then running 11 projects.