View Full Version : z-motor
aokweld101
02-03-2013, 06:59 PM
its showing error on the z-motor I have 486 hrs. on it I take it is time to change it or is there some other things to do...
henry1
02-03-2013, 07:07 PM
more detail please, does give you error when going up and down or taking a reading
aokweld101
02-03-2013, 07:16 PM
taking a reading I was carveing a 14.5 x 55in board.
aokweld101
02-03-2013, 07:19 PM
also cut motor showed error and wouldnt come on just changed brushes yesterday
aokweld101
02-03-2013, 07:38 PM
59737here is a drawing that i was trying
Digitalwoodshop
02-04-2013, 11:03 AM
More than likely the Cut Motor Brushes let the motor stop and that is what caused the Z Stall...
Brushes should be replaced about 250 cut hours as once they get short they stall the cut motor and if your doing a Cut Path can snap the $40.00 bit.
Read up on the 250 hour maintenance.
Save on Shipping by buying all the required stuff at once. Your Y Bearings are SHOT too...
Good Luck,
AL
aokweld101
02-04-2013, 12:24 PM
AL, as I said I changed the brushes day before and done a carve, the cut motor came on and done the carve went well, the stall came on as I was doing the carve on the jewery box I think that I had a slight bow in the 55" lenght I'm going to just half the project and see if it will work, I do need the bearings, y truck y & z motors, I'm going to see If I can bleed one more project out of it...lol
Digitalwoodshop
02-04-2013, 07:05 PM
AL, as I said I changed the brushes day before and done a carve, the cut motor came on and done the carve went well, the stall came on as I was doing the carve on the jewery box I think that I had a slight bow in the 55" lenght I'm going to just half the project and see if it will work, I do need the bearings, y truck y & z motors, I'm going to see If I can bleed one more project out of it...lol
Missed that little detail in the next post... Good Luck,
AL
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.