Old Salt
02-04-2007, 09:50 PM
I had some one ask me to reproduce some old corner blocks ,somtimes called targets, they are 5" sq. 1" thick. he only need 10 so specal ordering of a drill press cutter was to much cost . I tried scaning the block but just was not crisp .
Then the light came on!
TRY this
open new board 6 x6 x 1 .
Draw circle set .75 dim 1/2 " Classical bit set depth .315 ,center both ways ,-
Draw circle set 1.5" dim I chose 1/2 " 60/v Bit but used 1/2 vaning bit set at .20 center both ways
Draw 5" Sq box use 60 v bit or 1/4 round over bit a .15
I would show pattern but I think you will have more fun seeing it come together
To easy to believe
Then the light came on!
TRY this
open new board 6 x6 x 1 .
Draw circle set .75 dim 1/2 " Classical bit set depth .315 ,center both ways ,-
Draw circle set 1.5" dim I chose 1/2 " 60/v Bit but used 1/2 vaning bit set at .20 center both ways
Draw 5" Sq box use 60 v bit or 1/4 round over bit a .15
I would show pattern but I think you will have more fun seeing it come together
To easy to believe