PDA

View Full Version : installing replacement z-drive help



howsharbell
02-04-2007, 08:29 PM
I received my new z-drive (after my other one did a fatal error, carving into the securing latch under my project 5 minutes into my FIRST project, breaking my bit and leaving me swearing..) but it didn't come with any installation info. I'm assuming it's pretty straight forward but has anyone done this? i'm going to give it a try and hope customer service is open on Sundays if i can't figure it out.

Shari
(hi, "the Bard" I chated with you when I had my new z-drive sent to me, thanks for being patient with me...)

The Bard
02-04-2007, 10:44 PM
Just Bard is fine.

call us up and we'll talk you through it. checking the .PDF on how to remove the cover will be a good start and then it's just two screws, one allen screw, and four cables. Ask for me and I'll help you out since its an easy fix.

anyone who works with crafting tools is either patient, or an ex-owner hehe.