PDA

View Full Version : x-axes



aokweld101
01-28-2013, 01:56 AM
I hope all the seniors member understand all the questions that I have asked and thank you for understanding..I done a carve the other day and forgot to turn on the vaccum for the dust collection, the next carve that I started the x axes stalled on me it rotatates about a 1/4 of an in. and stalls my ? is maybe I have to check the gears to make sure that no dust is stopping the gears ..

henry1
01-28-2013, 05:54 AM
That would be right or you might have teeth broken or some debree under your sand paper

chief2007
01-28-2013, 06:57 AM
Try the users test, from the main menu on the key pad press 0, then press 8, then press enter and then press enter again, if it faults running the test, most likely a bad x termination board.

aokweld101
01-28-2013, 04:01 PM
I'm getting a little better at this troubleshooting, I was on the money with the problem. I had debree stopping the gears while I had the machine apart done a complete clean-up, running like a top.......

chief2007
01-28-2013, 04:04 PM
Great job!