View Full Version : air exhaust?
Dodadd1
01-19-2013, 02:52 PM
I bought a new dust exhaust assembly from carvewright. The two plastic parts separate when a carve starts. Should there be a "O" ring where they join?
Can I glue the parts together?
Bill
fwharris
01-19-2013, 03:07 PM
What type did you get?
Dodadd1
01-19-2013, 03:23 PM
Muffler/Vacuum Bag Assembly MWM A2116
ladjr
01-19-2013, 04:16 PM
no. it should just slip inside the hole. I duct tape mine because it kept coming out
fwharris
01-19-2013, 04:23 PM
I had to go check to be sure and Leo is right they just snap together. On the fitting that goes into the back of the machine, there are a few ribs that look like they are suppose to go over the rings on the outer fitting. If needed do like Leo and tape it on...
Dodadd1
01-19-2013, 05:36 PM
Thank you! I'll just tape it so I don't have a missile flying across the shop. lol
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.