PDA

View Full Version : Help with carve region



dehrlich
01-18-2013, 08:21 PM
See the attached MPC. The 4x6 square that has the angel wings on each side is where a picture is going to go. I want it to be slightly deeper than the rest of the region, but i'm doing something wrong, all it wants to be is higher. What am I missing?

Also does anyone have a cooler angel that then one i'm using with the baby? This is for a lady that passed on at a rest home. Your assistance is appreciated!

59057

TerryT
01-18-2013, 08:34 PM
Try this. I just used merge subtractive.

dehrlich
01-18-2013, 08:40 PM
Try this. I just used merge subtractive.

That works. Thank you!

TerryT
01-18-2013, 08:42 PM
No problem.

badbert
01-18-2013, 11:33 PM
Good job Terry! I would have had to go review AskBud's videos! And nice project derlich! I was/am going to use that angel on my next project.

bjbethke
01-19-2013, 01:12 AM
See the attached MPC. The 4x6 square that has the angel wings on each side is where a picture is going to go. I want it to be slightly deeper than the rest of the region, but i'm doing something wrong, all it wants to be is higher. What am I missing?

Also does anyone have a cooler angel that then one i'm using with the baby? This is for a lady that passed on at a rest home. Your assistance is appreciated!

59057

I have another image of an angel with out the child. PM me if you think this would work. BJB