X axis reads wrong Dim.

[Bill Binns]

I've tried to change the dim. by manually calibrating the X-axis instructiopn in the manual. My machine registers the # short by 1.032 inches. I go to (2) New # and have put in e measured length. the difference in the machine # and my measured # is 1". By the instructions in the manual i am supposed to inter the # +32 sence the machine # is shorter than the measured #. My keypad has no (-) or (+) so when I do inter A # of 32 it States the # is out of range? Does anyone have insight into this problem?:oops:

[fwharris]

Look at the up and down arrows for the - + signs...

[bergerud]

If I recall, you have to set the numbers to zero first or otherwise calculate what the new number should be. The instructions assume the current numbers are zero. (Unless it was fixed!)