PDA

View Full Version : why it do that !



aokweld101
01-15-2013, 09:21 PM
I was doing the cookie box today, I've tried it before and it downsized it so I give up on the frist try so think that it downsized it because of the board was'nt long enough, well today I tried again and it asked me for a 90% v bit and it ran a two inch line on the other side of the carve then ask me for the for the 1/8 cuttng bit and did it thing, sizeing was right, my carve went fine, I am courious as to why it promted me for the 90% bit. does anybody know why?

fwharris
01-15-2013, 10:11 PM
Some where in your design you must have placed the line and selected the bit. Review your layout..