myshop1044
01-14-2013, 07:30 PM
I read about the cutting 45 deg angles on the edge of a board.
so I got instrested in setting it up. I laid out 2 sides of a box with
a 1/2" x 3/8" dados and the angles too. It would be faster on a router
table and a table saw, but my chop saw can't do 5" board width and my
table saw is old and I put a a self maded dust collection on it and I cannot cut 45deg
on it with out taking off the DC. So here is my attempt on CW and I must say
this will give me a way out. The corners were perfect 90 deg. and dado was
perfect too.
I,m loving the machine more each day.
Oh well back to production carving tomorrow.
Perry B.
so I got instrested in setting it up. I laid out 2 sides of a box with
a 1/2" x 3/8" dados and the angles too. It would be faster on a router
table and a table saw, but my chop saw can't do 5" board width and my
table saw is old and I put a a self maded dust collection on it and I cannot cut 45deg
on it with out taking off the DC. So here is my attempt on CW and I must say
this will give me a way out. The corners were perfect 90 deg. and dado was
perfect too.
I,m loving the machine more each day.
Oh well back to production carving tomorrow.
Perry B.