putting legs on box

[aokweld101]

I'm wanting to put 1/4 legs on this box could someone show me how I have the two end pieces I would like to put the legs on..

[fwharris]

Are the legs the circles on the back side of the board? If so make them a carve region with a 0 height.

[aokweld101]

Hi floyd, I did a carve region at 0. hieght but I keep losing the leg and if I select all the legs they dissapear. I must be pushing the wrong button...I'm in a zombie mode agian...lol

[bjbethke]

I'm wanting to put 1/4 legs on this box could someone show me how I have the two end pieces I would like to put the legs on..

Is this what you are looking for?

[mathman]

1) click on circle(s) for the leg(s)
2) click on Carve Region
3) change depth from 0.250 to 0

If it was me and all I wanted was round legs, I wouldn't carve the bottom side (eliminate the 0.250 carve region so you have room for the legs) and instead have it drill a hole for the leg. Then use a dowel the size of the hole to make the leg.

[bjbethke]

Hi floyd, I did a carve region at 0. hieght but I keep losing the leg and if I select all the legs they dissapear. I must be pushing the wrong button...I'm in a zombie mode agian...lol

You need to use the Merge function on the Carve Region.

[SteveNelson46]

aokweld101

In this example I set the carve region to a depth of .25", deleted your feet, and re-created a foot using a .5" circle carve region with a depth of "0". Then I mirrored it in all four directions. I also set the merge to normal for the large carve region

[DickB]

I use a depth of .001". Same result, except I don't get the software complaining about it.