Interrupted Carving

[Carl H]

Today I put a patterns on a board, twice. One on best and one on good.
Then I set the upload at best not optimal. I wanted to see the difference in quality.
I was carving red oak. I know it isnt the best for certain projects but it is what I had.

I was cleaning up outside the machine and about to open the door when the machine shut down.
I looked and the cord got bumped in the extension socket.
There was maybe 5 minutes left, just v carving some letters.

I know you can re run the carve but the little bit that was left isnt worth it. I will carve by hand that last little bit.

I think it is time to clear up my shop :p.
I did see a slight difference between the two carvings, I may run the same project again tomorrow on Optimal setting. Double the time, but who knows it may be worth it.

Something I have noticed when rendering with the software though is I seem to get better visual results on the monitor by not using the best setting but the one under it. I have no idea how this translates to the actual carve.

Any comments would be appreciated.

[fwharris]

Carl,

You can go back and modify the original project and carve the items that are left. Since it is just V carving, delete what has already been carved and re save the project. Load up the machine to finish up...