jerryberg
12-25-2012, 08:50 AM
Hi all, newbie here from Ruston, LA. I'm actually a painter and am starting to make a few of my own frames as experiments. Here is my first project on my carvewright that is a small frame that I am currently working on. Still in the middle of gilding it.
5804658045
My question is that I want to create a tondo frame (circle). I want the center to be raised and the outer edge to be a lower profile. I have done that by just making a pattern in photoshop. So the question is, that I have set up a bunch of filigree patterns that I want to map to the curved pattern. Is this possible?
Here is the curved surface.
58048
Here are the filigree patterns.
58047
Any help would be greatly appreciated.
Thanks,
Jerry
- - -
Jerry Berg
http://www.jerryberg.com
5804658045
My question is that I want to create a tondo frame (circle). I want the center to be raised and the outer edge to be a lower profile. I have done that by just making a pattern in photoshop. So the question is, that I have set up a bunch of filigree patterns that I want to map to the curved pattern. Is this possible?
Here is the curved surface.
58048
Here are the filigree patterns.
58047
Any help would be greatly appreciated.
Thanks,
Jerry
- - -
Jerry Berg
http://www.jerryberg.com