PDA

View Full Version : help with a pattern how to change settings



scoobie_6
12-22-2012, 04:09 PM
hi, i got this off the pattern sharing that someone put up. don't know who. but i want to carve this with a 3/4 in thick board and it looks like it is setup for a 1 inch board.how can i change the depth of all the carvings ? can someone please help me with this?5799857998

ladjr
12-22-2012, 04:56 PM
57999

Is this what you have in mind. If so you need to change the board in Edit to .75, then change each carve item.

gwhiz
12-22-2012, 05:04 PM
You'll need to change each carving individually-it'll only take a couple of minutes. Right click on the board to change the board setting and set the thickness to .75. (if you choose the cutout in the carving list, then right click and deselect "Hide cutout" it may be easier as you can see the entire board. Put your cursor on a corner and right click to see the "Board Settings selection").

You'll see that a couple of the carves now carve through the board. Click on each object in turn and set the depth to .5 or your depth of choice wherever it now says .75.

Save it, load it, and carve it.

*OR--what Leo said!*;)

badbert
12-22-2012, 07:40 PM
You'll need to change each carving individually-it'll only take a couple of minutes. In this case you can highlight all of the carvings (not the cut path) and change the depth all at once.

scoobie_6
12-22-2012, 08:05 PM
ok will give a try thanks alot you guys are great :D

SteveNelson46
12-23-2012, 10:41 AM
I changed just about everything. Depth, Bit Quality, Feather, etc.. Even the stuff on the back. Select each object and check the settings.